Gasket Sheet AF-SUPERSOFT
APPLICATION:
A soft and flexible gasket sheet designed specifically for repairing old, uneven and damaged flanges and joints. An ideal solution where even distribution of assembly stresses on the contact surface of the gasket with the flange is difficult.
| MATERIAL: |
Kevlar® aramid fibres, mineral fibres, fillers, NBR rubber
Kevlar® is a registered trademark of E. I. du Pont de Nemours and Company or its affiliates. |
||
| Designation according to DIN 28091-2: | FA-CM1-O | ||
| ADMISSIONS / CERTIFICATES: | |||
| Maximum working conditions: | |||
| Peak temperature | 0C | 290 | |
| Temperature under continuous operation | 0C | -40 - 220 | |
| Temperatura pracy ciągłej w parze | 0C | 180 | |
| Pressure | MPa | 6 | |
| Dimensions: | |||
|
Standard thicknesses of sheets /thicknesses above 5.0 mm are produced by gluing/ |
mm | 1,0;1,5; 2,0; 2,5; 3,0; 4,0; 5,0 | +/- 10% |
|
Standard dimensions of sheets /custom dimensions available within the total range of 1500x3000 mm/ |
mm | 1500x1500 | +/- 10,0 |
| Physical and Chemical Properties: | |||
| Density (+/- 5 %) | g/cm3 | 2,0 | DIN 28090-2 |
| Transverse tensile strength min. | MPa | 7 | DIN 52910 |
| Compressibility | % | 13 - 18 | ASTM F36 |
| Elastic recovery - min. | % | 50 | ASTM F36 |
| Residual stresses 50MPa/16h/300ºC/ (min.) | MPa | 17 | DIN 52913 |
| Residual stresses 50MPa/16h/175ºC/ (min.) | Mpa | 33 | DIN 52913 |
| Increase in thickness: | |||
| Oil IRM 903 150oC/5h (max) | % | 6 | ASTM F146 |
| Model fuel B B 20oC/5h (max) | % | 6 | ASTM F146 |
| Colour | Bright yellow | ||
The values in the table refer to the gasket sheets with a thickness of 2.0 mm.
All information in this catalogue is based on years of experience in manufacture and use of the discussed products. Since sealing performance in the joint is subject to multiple factors such as mounting method, system parameters, and sealed medium, technical parameters specified herein are of informative nature only and cannot be used as grounds for any claims; any special uses of products are subject to consulting with the manufacturer.